Abstract
In applied research, a lack of understanding of corner stall, i.e. the three-dimensional (3D) separation in the juncture of the endwall and blade corner region, which has limited the efficiency and the stability of compressors. Both Reynolds-averaged Navier-Stokes (RANS) and large eddy simulation (LES) still need to be calibrated for turbomachinery applications. In the fundamental research of the turbulent boundary layer (TBL), there are a lot of findings of the effects of curvature and pressure gradients, which also play an important role in physics of corner stall. The purpose of this thesis is (i) to carry out an experiment in a cascade, (ii) to gain a database that could be used to calibrate both RANS and LES, and (iii) to give some basic explanations of corner stall through investigating the TBL on the suction side at the mid-span which is more complex than those in the basic investigations but simpler than those in a real engine.
A detailed and accurate experiment of 3D flow field through a linear compressor cascade has been set up. Experimental data were acquired for a Reynolds number of 3.82×10 ^5 based on blade chord and inlet flow conditions. Measurements have been achieved by hot-wire anemometry, pressure taps on blade and endwall, five-hole pressure probe, oil visualization, 2D particle image velocimetry (PIV),and two-component laser Doppler anemometry (LDA). An original and complete database was thus obtained.
The TBL on the suction side at mid-span was investigated. The wall-normal negative pressure gradient restrains the separation, on the contrary to its influence in the corner stall. The streamwise adverse pressure gradient can be responsible for the development of Reynolds stresses. The remarkable phenomenon at measurement stations near the trailing edge of blade is that an inflection point occurs in each profile of the mean streamwise velocity. At this inflection point, the magnitudes of the Reynolds stresses reach their maximum values, and the direction of energy diffusion also changes.
The velocity field in the corner stall was presented. Bimodal histograms of velocity exist in the experiment. The bimodal points mainly appear in the region around the mean interface of separated flow and non-separated flow. At a bimodal point the local two velocity components are non-independent from each other, due to the aperiodic interplay of two basic modes in the flow field. Two modes were proposed to interpret the physics of bimodal behaviour.
Time：15:00-16:30,December 5th,2012
Venue:1512#,YiFu Technology and Science Building
